Measurement Data Memory; Editing The Measurement Data Memory - wtw VWR MU 6100 H Operating Manual

MU 6100 H
Terminating the
automatic memory
function prema-
turely
Editing the data
memory
ba77077e06 05/2021
saving mode switches off functions of the meter that are not required for the
automatic storage of measurement data (such as the display). By pressing any
key the energy saving mode is switched off again.
Proceed as follows to switch off the automatic data storing function before the
adjusted storing duration has expired:
<STR
1. Press the
The following window appears.
Warning
Stop automatic storage?
Yes
No
15.02.2014
Back
< >< >
2. Using  
The meter switches to the measured value display.
The automatic data storing function is terminated.

12.3 Measurement data memory

12.3.1 Editing the measurement data memory

The contents of the manual or automatic measurement data memory can be
shown on the display and output to the interface.
Each of the measurement data memories has a function to erase the entire
contents.
The memory is edited in the menu, Storage & config/ Data storage. To open the
Storage & config menu, press the
Open the manual or automatic storage directly with the
key.
The settings are explained here using the manual data memory as
an example. The same settings and functions are available for the
automatic data memory.
_
>
key.
14:15
, select Yes and confirm with
_
<OK
Data memory
<OK>
.
>
key in the measured value display.
<RCL> <RCL__ >
or
77