Replacing A Him/Mim/Mic - H3C SR6600-X Series Manual

Figure5-4 Pulling the FIP module out of the slot
4. Install a new FIP module. For the installation procedure, see
If you do not install a new FIP module in the slot, install a filler panel.

Replacing a HIM/MIM/MIC

IMPORTANT:
After you remove a HIM/MIM/MIC from a FIP, the HIM/MIM/MIC settings will not automatically
restore if you reinstall the HIM/MIM/MIC on the FIP after the FIP reboots. To save the settings, make
sure the HIM/MIM/MIC is in position before rebooting the FIP module or inserting the FIP module
into the router.
The replacement procedures for HIMs, MIMs, and MICs are similar.
To replace a HIM/MIM/MIC:
1. Face the front of the router and locate the HIM/MIM/MIC to be removed.
2. Completely loosen the captive screws of the HIM/MIM/MIC.
3. Fully open the ejector levers on the HIM/MIM/MIC. Hold the ejector levers and then gently pull
the HIM/MIM/MIC out of the slot along the slide rails.
The ejector levers of the FIP module are long. When removing the HIM/MIM/MIC in slot 1 on the
FIP module, avoid touching the right ejector lever of the FIP module.
Figure5-5 Removing a HIM/MIM/MIC
53
"Installing an LPU."