Table of Contents
Advertisement
SC-F6400 Series/SC-F6400H Series
Feeding or Ejecting Problems
Unable to feed or eject paper.
Is the media loaded in the correct position?
o
See the following for the correct media loading
positions.
"Loading Media" on page 36
U
If the media is loaded correctly, check the condition
of the media that you are using.
Is media curled, folded, curved, creased, or
o
wavy?
Cut and remove the curled, folded, curved, creased,
or wavy part.
"Cutting Media" on page 42
U
"Make settings for Loaded Media" on page 36
U
Is media loaded just before printing?
o
The rollers may crease media left in the printer, or
the media may also become wavy or curled.
Is the media too thick or too thin?
o
❏
Check the media specifications to determine
whether it can be used in the printer.
"Supported Media" on page 98
U
❏
For information on how to configure print
settings using the software RIP, contact the RIP
manufacturer.
Is Paper Suction set too high?
o
If you continue to have problems with media
ejection, try lowering the Paper Suction (the
amount of suction used to keep the media on the
paper feed path). U
page 78
User's Guide
Problem Solver
"Media Settings Menu" on
Media jams
Check the error displayed on the control panel screen,
and then follow the on-screen instructions to remove
the media.
After removing the media, press Cancel Print on the
following screen to remove the print job. Press to
restart printing from the beginning.
Press Finish, and then reload the media to print the
rest of the print data.
Others
The control panel display keeps
turning off.
Is the printer in sleep mode?
o
When no operations are performed on the printer
for the time set in Sleep Timer in the setup menu,
the printer enters sleep mode. You can change the
time before entering sleep mode in the General
Settings menu.
"General Settings Menu" on page 71
U
92
Advertisement
Table of Contents
