GE Brivo OEC 715 Service Manual page 432

4. Loosen the screws of the plate cover of the
brake and remove the plate cover.
5. Remove the screws and replace the brake
pad assembly.
6. Reassemble the covers of the cross arm.
7. Replace the new horizontal movement handle. Pay attention to keep the original assembling direction.
8. Place the handle in unlock position. Verify that you can push or pull the cross arm and lock the cross
arm by placing the brake handle in lock position.
C-Arm Steering Handle (5333084)
1. Remove the cosmetic cover of steering handle.
2. Remove the 2 screws of the steering handle.
3. Remove the handle.
4. Install the new handle and fasten the screws.
Pay attention to keep the original assembling
direction.
5. Verify that the rear wheel can be steered by
the steering handle.
Workstation Handles (5075914)
Refer to section 7.3.1 Workstation covers to remove the Workstation handles.
Mainframe Front Wheel Kit (5075902)
Replacement
7-25