GE Brivo OEC 715 Service Manual page 187

4. Press the laser aimer's green ON switch to generate the laser beam.
5. Loose the set screw a little inside so that you
can adjust the beam by the adjuster.
6. Adjust the adjusters of the laser until the intersection of the laser beam is in the center circle of
the beam alignment tool. (Use the circle to adjust the line to be vertical with the other and the
screws to adjust the position of the line.)
7. Fasten the set screw a little. And the beam position
will change a little. Then adjust the beam again
according to step5. Fasten the set screw to fix the
beam position and direction. Then install the laser
aimer cover.
8. Functional check: Turn on the laser aimer power
switch and verify that the intersection of the laser
beam is in the center circle of the beam alignment
tool and the two laser lines are vertical.
Laser Aimer on Image Intensifier
Perform the following procedure to install and operate the laser aimer on the Image Intensifier. The C-
Arm can be placed in any orientation that is convenient for attaching the laser aimer. There are no
alignment marks or notches on the laser aimer that need to match any points on the image intensifier.
Set Screw
Installation
Circle adjuster
3-51