GE Brivo OEC 715 Service Manual page 135

Function Button Quick-Reference
Function Button
Power
Power On
Power Off
Display
Status Inquiry
Full-Time/Power-
Saving mode
Mute
Event Specific
General Status
Enable/Disable
Sensitivity
Master/Controlled
outlet Enable/Disable
Master/Enable
Threshold
Calibration
Self-Test (manual)
Event Reset
Fault Reset
Timing UPS Status Description
(seconds)
0.2 Off Press POWER to start receiving input utility
power. If A/C input power is not available, the
unit will run on battery power.
2 On The unit is not receiving input utility power, but
is providing surge protection.
0.2 On Verify the status or condition of the unit. The
LCD will illuminate for 60 seconds.
2 On The LCD will illuminate and the unit will beep to
confirm the Full-Time mode. The LCD will
darken and the unit will beep to confirm the
Power-Saving mode. While in Power-Saving
Mode, the LCD will illuminate if a button is
pressed, then darkens after 60 seconds of no
activity.
0.2 On Disable any audible alarms caused by an
event.
2 On Enable or disable the audible alarms. The Mute
icon will illuminate and the unit will beep one
time. The Mute function will not activate unless
the UPS is operating on battery power.
6 Off The Load Capacity icon will blink, indicating
that the unit is in programming mode. Use the
POWER button to scroll through Low, Medium,
and High, stop at selected sensitivity. The unit
will beep to confirm selection. See
Configuration for details.
2 On The leaf icon will darken indicating that the
Master Outlet feature is disabled or illuminate
to indicate the Master Outlet feature is
enabled. The unit will beep once.
6 On While calibrating the threshold setting, the
device connected to the Master Outlet should
be turned off or placed in Standby or Sleep
mode. Upon completion, Power-Saving icon
will flash 3 and beep 3 times.
6 On The UPS will perform a test of the internal
battery. Note: This will happen automatically
when the unit is turned ON.
0.2 On When the Event screen is visible, press and
hold DISPLAY, then press POWER, to clear the
utility failure event counter.
2 Fault After a fault has been identified, press POWER
to remove the visual indication and return to
standby status.
System Overview
2-81