Management Port Leds In Ex3200 And Ex4200 Switches - Juniper EX3200 Series Complete Hardware Manual

Table 8: Status LED on Network Ports in EX3200 and EX4200 Switches (continued)
LED
Related Topics

Management Port LEDs in EX3200 and EX4200 Switches

Copyright © 2010, Juniper Networks, Inc.
LCD Indicator
Front Panel of an EX3200 Switch on page 7
Front Panel of an EX4200 Switch on page 9
Uplink Modules in EX3200 and EX4200 Switches on page 34
LCD Panel in EX3200 and EX4200 Switches on page 13
The management port on EX3200 and EX4200 switches has two LEDs that indicate
link/activity and port status (see Figure 15 on page 26 or Figure 16 on page 26). The
management port is set to full-duplex and the speed is set to 100 Mbps.
Chapter 2: Component Descriptions
State and Description
Indicates the speed.
The speed indicators for network ports on the front panel are:
One blink per second—10 Mbps
Two blinks per second—100 Mbps
Three blinks per second—1000 Mbps
The speed indicators for network ports on the SFP uplink
module are:
Green—1000 Mbps
Unlit—10/100 Mbps
The speed indicators for network ports on the SFP+ uplink
module are:
Green—The speed of the transceiver installed in the port is
the same as the speed at which the uplink module port is
configured to operate.
Unlit—The speed of the transceiver installed in the port is
not the same as the speed at which the uplink module port
is configured to operate.
The speed of the XFP uplink module ports is always 10 Gbps;
therefore, the LED is always green.
25