Juniper EX3200 Series Complete Hardware Manual page 41

Table 4: LCD Panel Menu Options in EX3200 and EX4200 Switches (continued)
Menu Description
MAINT The Maintenance menu has the following options to configure and troubleshoot the switch:
(Maintenance
SYSTEM HALT?—Choose one of the following:
Menu)
Press the
Press the
SYSTEM REBOOT?—Choose one of the following:
Press the
Press the
LOAD RESCUE?—Choose one of the following:
Press the
to confirm the rollback.
Press the
REQUEST VC PORT?—Choose one of the following:
Press the
Chassis port (VCP) or to delete a VCP from the switch configuration (when you delete the VCP, the port
is reset to an uplink module port or an EX4200-24F network port).
Press the
FACTORY DEFAULT?—Choose one of the following:
Press the
again to confirm the restoration.
Press the
ENTER EZSETUP?—Choose one of the following:
Press the
NOTE: You can use the ENTER EZSETUP option only if the switch is in the factory default configuration.
For information about EZSetup, see "Connecting and Configuring an EX Series Switch (J-Web Procedure)"
on page 167.
Press the
EXIT MAINT MENU?—Choose one of the following:
Press the
Press the
If you do not want users to use Maintenance menu options, disable the entire menu or individual menu options.
See Configuring the LCD Panel on EX Series Switches (CLI Procedure).
Related Topics
Copyright © 2010, Juniper Networks, Inc.
button to halt the switch. Press the
Enter
button to go to the next option in the Maintenance menu.
Menu
button to reboot the switch. Press the
Enter
Menu button to go to the next option in the Maintenance menu.
Enter button to roll back the switch to the rescue configuration. Press the
button to go to the next option in the Maintenance menu.
Menu
button to configure an uplink module port or an EX4200-24F network port to be a Virtual
Enter
Menu button to go to the next option in the Maintenance menu.
button to restore the switch to the factory default configuration. Press the
Enter
button to go to the next option in the Maintenance menu.
Menu
button to launch EZSetup. Press the
Enter
button to go to the next option in the Maintenance menu.
Menu
Enter button to exit the Maintenance menu. Then press the
Menu button to go to the System Halt option.
Front Panel of an EX3200 Switch on page 7
Front Panel of an EX4200 Switch on page 9
Field-Replaceable Units in EX3200 and EX4200 Switches on page 18
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 165
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 167
Chapter 2: Component Descriptions
button again to confirm the halt.
Enter
button again to confirm the reboot.
Enter
button again to confirm the launch.
Enter
Menu button to go to the Idle menu.
Enter button again
button
Enter
17