Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper EX4200-24T Hardware Manual

EX4200 Switch Hardware Guide
Related
Documentation

Connecting and Configuring an EX Series Switch (J-Web Procedure)

168
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 168
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX2300 Switch
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX3300 Switch
Installing and Connecting an EX3400 Switch
Installing and Connecting an EX4200 Switch on page 127
Installing and Connecting an EX4300 Switch
Installing and Connecting an EX4550 Switch
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX6210 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: You cannot connect to and perform initial configuration of
EX2200-24T-4G-DC and EX4600 switches using EZSetup procedure from
the J-Web interface. For EX2200-24T-4G-DC switches, you must use EZSetup
from the switch console, and for EX4600 switches, you must use the CLI
procedure through the switch console.
This topic describes the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC that you will connect to the switch so that the PC can obtain
an IP address dynamically.
Copyright © 2017, Juniper Networks, Inc.