Related Topics
Replacing a Member Switch of a Virtual Chassis Configuration (CLI Procedure)
Copyright © 2010, Juniper Networks, Inc.
Gently pull the release pull tab on the Virtual Chassis cable connector to release the
3.
lock holding the Virtual Chassis cable connector in the Virtual Chassis port.
Gently pull the Virtual Chassis cable connector out of the Virtual Chassis port.
4.
Figure 73: Virtual Chassis Cable Connector in an EX4200 Switch
NOTE: If you order Virtual Chassis cables separately, you must reuse the locking covers
provided with the original cable or order Virtual Chassis cable locking covers also
separately.
Connecting a Virtual Chassis Cable to an EX4200 Switch on page 139
Understanding Virtual Chassis Hardware Configuration on an EX4200 Switch on
page 105
Understanding Virtual Chassis Components
Planning the Virtual Chassis on page 106
Virtual Chassis Ports Connector Pinout Information for EX4200 Switches on page 81
You can replace a member switch of a Virtual Chassis configuration without disrupting
network service for the other members. You can retain the existing configuration of the
member switch and apply it to a new member switch, or you can free up the member ID
and make it available for assignment to a new member switch.
Chapter 13: Removing Switch Components
Virtual Chassis cable connector
Release pull tab
Cable connector retainer
183