Chassis Lifting Guidelines For Ex3200 And Ex4200 Switches; Ramp Warning For Ex Series Switches - Juniper EX3200 Series Complete Hardware Manual

Hide thumbs Also See for EX3200 Series:
Table of Contents

Advertisement

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches
Related Topics

Chassis Lifting Guidelines for EX3200 and EX4200 Switches

Related Topics

Ramp Warning for EX Series Switches

220
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
General Safety Guidelines and Warnings for EX Series Switches on page 207
Laser and LED Safety Guidelines and Warnings for EX Series Switches on page 213
Grounded Equipment Warning for EX Series Switches on page 226
Connecting AC Power to an EX2200 Switch
Connecting AC Power to an EX3200 or EX4200 Switch on page 147
Connecting AC Power to an EX4500 Switch
Connecting AC Power to an EX8200 Switch
Connecting DC Power to an EX3200 or EX4200 Switch on page 149
Connecting DC Power to an EX8200 Switch
The weight of a fully loaded EX3200 or EX4200 switch chassis is approximately 22 lb
(10 kg). Observe the following guidelines for lifting and moving an EX3200 or EX4200
switch:
Before installing an EX3200 or EX4200 switch, read the guidelines in "Site Preparation
Checklist for EX3200 and EX4200 Switches" on page 87 to verify that the intended
site meets the specified power, environmental, and clearance requirements.
Before lifting or moving the EX3200 or EX4200 switch, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings for EX Series Switches on page 207
Installation Instructions Warning for EX Series Switches on page 219
Mounting an EX3200 or EX4200 Switch on page 120
WARNING: When installing the switch, do not use a ramp inclined at more than 10
degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10 graden.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents