Table 12: Minimum Power Requirements For An Ex4200 Switch - Juniper EX3200 Series Complete Hardware Manual

Table 11: Minimum Power Requirements for an EX3200 Switch (continued)
Model Number
EX3200-48T
EX3200-24P
EX3200-48P
EX3200-24T-DC
EX3200-48T-DC

Table 12: Minimum Power Requirements for an EX4200 Switch

Model Number
EX4200-24T
EX4200-48T
EX4200-24P
EX4200-48P
EX4200-24F
EX4200-24T-DC
EX4200-48T-DC
EX4200-24F-DC
Copyright © 2010, Juniper Networks, Inc.
Number of PoE-enabled Ports
8
24
48
0
0
Table 12 on page 29 lists the minimum power requirements for each model of EX4200
switch. The maximum power available to each PoE port is 15.4 W.
Number of PoE-enabled Ports
8
8
24
48
–
0
0
–
To avoid electrical injury, follow instructions in "Installing a Power Supply in an EX3200
or EX4200 Switch" on page 132 and "Removing a Power Supply from an EX3200 or
EX4200 Switch" on page 174 carefully.
NOTE: After powering on an EX3200 or EX4200 switch, wait for at least 60 seconds
before powering it off. After powering off an EX3200 or EX4200 switch, wait for at least
60 seconds before powering it back on.
After an EX3200 or EX4200 switch has been powered on, it can take up to 60 seconds
for status indicators—such as LEDs on the power supply,
and messages on the LCD—to indicate that the power supply is functioning normally.
Ignore error indicators that appear during the first 60 seconds.
Chapter 2: Component Descriptions
Minimum Power Requirement
320 W
600 W
930 W
190 W
190 W
Minimum Power Requirement
320 W
320 W
600 W
930 W
320 W
190 W
190 W
190 W
command output,
show chassis
29