Where To Put The Restraint - HOLDEN WN CAPRICE 2014 Owner's Handbook Manual

3. To tighten the belt around the
installed child seat, push down
on the child restraint, pull the
shoulder portion of the belt to
tighten the lap portion of the belt
and feed the shoulder belt back
into the retractor.
4. Try to pull the belt out of the
retractor to make sure the
retractor is locked. If the
retractor is not locked, repeat
Steps 2 to 4.
5. To remove, press the release
button on the buckle and allow
the belt to fully retract.
Where to Put the
Restraint
Warning
Child restraint anchorages are
designed to withstand only those
loads imposed by correctly fitted
child restraints. Under no
Warning (Continued)
circumstances are they to be
used for adult seat belts,
harnesses, or for attaching other
items or equipment to the vehicle.
Only child restraints that have
clips to attach to the vehicle's
anchorage fitting (as shown in the
following illustrations) are to be
used. Earlier types of child
restraints may not attach securely
to this type of anchor.
Use only Standards Australia and
New Zealand approved child
restraints and harnesses. Only
purchase a child restraint which
carries the appropriate Standards
Australia sticker of approval.
Where legally allowable, you may
install a forward-facing child
restraint in the front seat, but
always move the passenger seat
as far back as it will go. The
(Continued)
Seats and Restraints
Warning (Continued)
forward facing child restraint must
still be attached to the passenger
side child restraint anchorage
point, located behind the
rear seat.
Remember, it is safest for children
to be seated in the rear seat.
child restraint anchor fitting, please
contact an approved restraint fitting
station or a Holden Dealer.
(Continued)
If unsure about installing a
3-21