Table of Contents
Advertisement
11. The vehicle may have a
second retaining nut and panel.
To access the tools, remove
the second retaining nut and
panel.
12. Remove the tools. See Tools
on page 10-35.
Remove the tool container from
the vehicle if required.
13. Loosen the wheel nuts in an
anticlockwise direction, one
half to a full turn, but do not
remove the wheel nuts.
Caution
Ensure that the wheel wrench is
fully unfolded.
14. Position the jack beneath the
jack location closest to the
wheel being changed.
The locations are identified by
cut-outs in the underside of the
door sill.
15. Wind the jack up by hand until
it engages with the jacking
point.
Ensure that the jack is not tilted
and the base is resting
squarely on the ground.
Vehicle Care
Warning
Failure to position the jack as
described could cause the vehicle
to slip off the jack.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
16. Unfold the wheel wrench so it
forms a right angle.
10-51
Advertisement
Chapters
Table of Contents
