Table of Contents
Advertisement
9-22
Driving and Operating
Caution
Sensors are not working when:
A confirmation tone does not
sound.
Park Assist Fault appears
on the DIC.
Check and clean the sensors.
If the problem persists, contact
your dealer.
The range of the rear sensors is
approximately 240 cm.
The range of the front sensors is
approximately 150 cm.
When an object is detected:
A warning tone sounds.
As the distance decreases, the
repetition rate of the tone
increases.
At a distance of about 30 cm,
the warning tone sounds
continuously.
If the distance remains constant,
after about 5 seconds, the tone
will stop.
If the distance to the object
increases, the tone will stop.
When reverse gear is selected
and the rear and front sensors
both detect objects, only the
closest object will be indicated.
If two objects at the same
distance are detected, the object
at the rear of the vehicle will be
given priority.
•
When reverse is selected the
animation is displayed on
the infotainment screen if the
Rear Vision Camera (RVC) is
de-activated, see Rear Vision
Camera (RVC) on page 9-26.
•
The default display Park Assist
or Rear View Camera may be
selected in the Park Assist mode
menu. See Default Display
Selection under Rear Vision
Camera (RVC) on page 9-26.
•
If the sensors are activated,
an animation will display the
detection range if the RVC is
de-activated.
•
If an object enters the range,
the sector will illuminate green.
When the distance decreases,
additional sectors will illuminate
and the colour will change to
yellow, orange and finally red.
•
Front sensor detection occurs
when PA is turned on by pressing
or by selecting reverse
X
gear first. The light in the button
illuminates.
Advertisement
Chapters
Table of Contents
