HOLDEN WN CAPRICE 2014 Owner's Handbook Manual page 191

Voice Recognition
The voice recognition system uses
commands to control the system
and dial phone numbers.
When using voice recognition:
The system may not recognise
voice commands if there is too
much background noise.
A tone sounds to indicate that
the system is ready for a voice
command. Wait for the tone and
then speak.
Speak clearly in a calm and
natural voice.
See Voice Recognition on
page 7-69.
Audio System
Sound comes through the vehicle's
front audio system speakers and
overrides the audio system. Use the
/VOL switch during a call to
change the volume level. The
adjusted volume level remains in
memory for later calls. The system
maintains a minimum volume level.
®
Bluetooth Audio
See Bluetooth Audio on page 7-38.
Pairing with Infotainment
Controls
®
A Bluetooth -enabled mobile phone
must be paired and then connected
to the vehicle before it can be used.
See your mobile phone
manufacturer's user guide for
®
Bluetooth functions before pairing
the mobile phone.
Pairing Information
®
A Bluetooth -enabled phone and
an audio playback device can be
paired to the system at the
same time.
Up to five devices can be paired
®
to the Bluetooth system.
The pairing process is disabled
when the vehicle is moving.
Pairing only needs to be
completed once, unless the
pairing information on the mobile
Infotainment System
phone changes or the mobile
phone is deleted from the
system.
Only one paired mobile phone
can be connected to the
®
Bluetooth system at a time.
If multiple paired mobile phones
are within range of the system,
the radio will connect to the first
phone in the list or to the phone
that was previously connected.
Pairing a Phone/Device
1. Touch Config on the Home Page
>
or press / .
2. Select Phone Settings.
3. Select Bluetooth.
4. Select Pair Device. The
infotainment system displays
Pairing Code: XXXX . Confirm
or enter number: If the device
supports a four-digit Personal
Identification Number (PIN), it
will display. The PIN is used in
Step 6.
7-77