Table of Contents
Advertisement
10-44
Vehicle Care
Tyre sealant
The sealant cannot seal sidewall
damage, large punctures, or a tyre
that has unseated from the wheel.
Follow the safety instructions on the
tyre sealant canister.
Check the expiry date on the tyre
sealant canister before use. The
tyre sealant canister must be
replaced before its expiry date.
There is only enough sealant to seal
one tyre.
After usage, the tyre sealant
canister and sealant-air delivery
hose must be replaced as an
assembly.
Replacement tyre sealant canisters
are available from a Holden Dealer.
Temporary puncture repair
1. All passengers must exit the
vehicle.
2. Inspect the damaged tyre.
Do not remove any objects that
have penetrated the tyre.
3. Unwrap the sealant-air delivery
hose (5) from the side of the
compressor.
4. Remove the 12 volt power
connection (6) from the kit.
Do not connect to the power
socket yet.
5. Unscrew the tyre valve cap
anticlockwise and remove.
6. Attach the sealant-air delivery
hose (5) onto the tyre valve.
Rotate it clockwise until tight.
7. Switch the on/off switch (1) to
the O position.
8. Plug the 12 volt power
connection into the vehicle
power socket. See Power
Outlets on page 5-9.
Do not jam the 12-volt power
connection cable in the door,
boot or window.
9. Start the engine and let it idle to
ensure the battery does not
run down.
Advertisement
Chapters
Table of Contents
