Table of Contents
Advertisement
Taillamp access
To access the taillamp turn signal
and reverse bulbs:
1. Open the boot.
2. Raise the spare wheel cover and
attach the T-piece to the boot lid.
See Tyre Changing on
page 10-49.
3. Unscrew and remove the four
convenience net retaining
screws securing the plastic
boot trim.
4. Grasp the plastic boot trim and
pull directly upwards to remove.
5. Remove the boot lining securing
pin(s) by rotating anticlockwise
and pulling down at the
same time.
6. Lower the spare wheel cover.
7. Pull the boot lining away to
reveal the rear of the lamp.
When replacing the boot lining
securing pin(s), push directly
into the hole(s).
8. To replace the trim, align the
guide tabs with the holes and
push the trim down.
9. When the trim is refitted ensure
the lip of the rubber boot seal is
positioned on top of the trim.
Vehicle Care
Rear turn signal and reverse
lamps
1. To access to the lamp assembly,
see Tail lamps on page 10-22.
2. From the rear of the assembly,
rotate the bulb holder
anticlockwise to release.
3. Lightly press the bulb and twist
anticlockwise out of the holder.
10-23
Advertisement
Chapters
Table of Contents
