Tread Depth - HOLDEN WN CAPRICE 2014 Owner's Handbook Manual

One or more TPMS sensors are
missing or damaged. The
malfunction light and the DIC
message, if equipped, should go
off when the TPMS sensors are
installed and the sensor
matching process is performed
successfully. See your dealer for
service.
Replacement tyres or wheels do
not match the original equipment
tyres or wheels. Tyres and
wheels other than those
recommended could prevent the
TPMS from functioning properly.
See Buying New Tyres on
page 10-42.
Operating electronic devices or
being near facilities using radio
wave frequencies similar to the
TPMS could cause the TPMS
sensors to malfunction.
If the TPMS is not functioning
properly, it cannot detect or signal a
low tyre condition. See your dealer
for service if the TPMS malfunction
light and DIC message, if equipped,
come on and stay on.
TPMS Sensor Matching
Process
Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
vehicle's tyres or replacing one or
more of the TPMS sensors. The
malfunction light and the DIC
message, if equipped, should go off
at the next ignition cycle. The
sensors are matched to the tyre/
wheel positions, using a TPMS
relearn tool. See your dealer if the
sensor positions need to be
matched.
Vehicle Care

Tread Depth

Replace the tyres when:
They are worn to the point
where the tread indicators
appear.
The tyres originally fitted to the
vehicle have built-in tread
indicators. When only 1.5 mm of
tread remains, these indicators
show as plain bars across the
tread pattern at regular intervals
around the tyre.
10-41