Front Turn Signal Lamps - HOLDEN WN CAPRICE 2014 Owner's Handbook Manual

3. Grasp the wiring connector/bulb
assembly and twist
anticlockwise one eighth of a
turn to remove.
4. Separate the bulb from the
wiring.
5. Install the new bulb into the
wiring connector.
6. Twist the wiring connector/bulb
assembly clockwise one eighth
of a turn to install.
7. Install the dust cap, ensuring the
rubber seal is in place.
8. Install components removed in
Step 1.
9. Check lamp operation.
Park lamps
Front park lamps
1. To access the headlamps, follow
the steps.
2. Remove the park lamp bulb
holder by rotating it
anticlockwise and pulling it
straight out.
Vehicle Care
3. Remove the park lamp bulb by
pulling it straight out of the
holder.
4. Insert the new bulb into the
holder. Ensure that the same
colour bulb is used.
5. Install the holder.
6. Install components removed in
Step 1.
7. Check lamp operation.

Front Turn Signal Lamps

1. To access the headlamps, see
Headlamps on page 10-18 and
follow the steps.
2. Remove the outboard dust cap.
10-21