Table of Contents
Advertisement
Maximum vehicle speed
Tyre clearance
Snow chain clearance
Tyres with heavy treads and those
made for better grip in the wet,
should only be operated within the
limits recommended by the
manufacturer.
Tyres with a higher speed or load
rating are acceptable, provided they
are fitted to a suitable rim size.
Warning
Tyres with a lower speed or load
rating are NOT acceptable for
fitment to the vehicle.
Replacing the factory fitted wheels
and tyres with non-genuine wheels
and tyres may affect the New
Vehicle Voluntary Warranty as well
as the vehicle's insurance policy.
Contact a Holden Dealer for advice
on suitable tyres.
Wheel Alignment and
Tyre Balance
Improper wheel alignment or
balance can cause:
Tyres to wear fast and unevenly
The vehicle to pull to one side
Vibration
If any of these problems exists,
have the vehicle checked by a
Holden Dealer.
Tyre condition is checked when the
vehicle is serviced by a Holden
Dealer. They are able to diagnose
any unusual signs of wear. If tyres
are rotated, it is recommended that
balance be checked at the
same time.
Tyre Chains
Due to lack of clearance, tyre chains
cannot be fitted to vehicles
equipped with the following wheel
and tyre configurations:
235/50R18 18 x 8
Vehicle Care
245/40R19 19 x 8
245/35R20 20 x 8.5
Tyre Sealant and
Compressor Kit
The vehicle may have an
emergency tyre sealant and air
compressor kit, in place of the jack,
tools and spare tyre.
The tyre sealant and air compressor
kit can be used to temporarily seal a
small puncture up to 6 mm in the
tread area of the tyre. It can also be
used to inflate an underinflated tyre.
The vehicle must be driven for 8 km
after the tyre is sealed and inflated
to the recommended pressure, to
ensure the sealant is distributed
evenly.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
10-43
Advertisement
Chapters
Table of Contents
