HOLDEN WN CAPRICE 2014 Owner's Handbook Manual page 304

10-48 Vehicle Care
10. Switch the on/off switch (1) to
the O position.
Warning
Be careful when handling the tyre
sealant and air compressor kit as
they may be hot after usage.
11. Disconnect the 12 volt power
connection (6) and the air-only
delivery hose (4).
12. Replace the tyre valve cap.
13. Place the tyre sealant and air
compressor kit back in
the boot.
Warning
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury during
heavy braking, sudden avoidance
manoeuvres or a collision.
Replacing the tyre sealant canister
After a temporary puncture repair,
replace the tyre sealant canister.
To remove the canister:
1. Unlock the air-only delivery
hose (4) from the tyre sealant
canister by pulling up on the
lever (7).
2. Pull the air-only delivery hose (4)
from the tyre sealant canister.
3. Unwrap the sealant-air delivery
hose (5) from the air
compressor.
4. Rotate the tyre sealant
canister (3) anticlockwise so the
sealant-air delivery hose (5) is
aligned with the slot in the
compressor.
5. Lift the tyre sealant canister (3)
from the compressor and
replace with a new tyre sealant
canister, available from a Holden
Dealer.
6. Dispose of the tyre sealant
canister at a Holden Dealer or in
accordance with local or State
codes and practices.
To install a new tyre sealant
canister:
1. Align the sealant-air delivery
hose (5) with the slot in the
compressor.
2. Push the tyre sealant
canister (3) down and rotate it
clockwise.
3. Wrap the sealant-air delivery
hose (5) around the compressor
channel.