Table of Contents
Advertisement
10-52
Vehicle Care
17. Slide the wheel wrench onto
the drive nut of the jack.
18. Turn the wheel wrench through
180 degrees.
19. Rotate the wheel wrench
clockwise.
20. Repeat Steps 18 to 19 until the
bottom of the flat tyre is about
5 cm above the ground.
21. Remove the wheel nuts and
place in a clean, dry place.
22. Exchange the wheel on the
vehicle with the spare wheel.
23. Replace the wheel nuts and
lightly tighten with the wheel
wrench.
24. Lower the vehicle by reversing
the jacking procedure.
25. Remove the jack from under
the vehicle.
26. With the wheel on the ground,
use the extended or unfolded
wheel wrench to tighten the
wheel nuts in the sequence
shown.
Warning
To tighten the wheel nuts, the
wrench must be fully unfolded.
Advertisement
Chapters
Table of Contents
