Table of Contents
Advertisement
10-46
Vehicle Care
Warning
Be careful when handling the tyre
sealant and air compressor kit as
they may be hot after usage.
15. Unplug the 12 volt power
connection (6) from the power
socket.
16. Rotate the sealant-air delivery
hose (5) anticlockwise and
remove.
17. Replace the tyre valve cap.
18. Place the tyre sealant and air
compressor kit back in the
boot area.
Warning
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury during
heavy braking, sudden avoidance
manoeuvres or a collision.
19. After inflating the tyre, remove
the maximum speed label and
place it in a visible location on
the instrument panel.
It reminds you to drive
cautiously and not to exceed
90 km/h until the damaged tyre
is replaced or repaired.
20. Drive the vehicle immediately
for at least 8 km to distribute
the sealant evenly within
the tyre.
21. Stop at a safe location to check
the tyre pressure. To inflate
tyres without sealant, see
Inflating tyres without sealant
later in this section.
22. If the tyre pressure has fallen
more than 10 psi (68 kPa),
below the recommended
inflation pressure, do not
continue driving. Contact a
Holden Dealer.
If the tyre pressure has
dropped less than 10 psi
(68 kPa), inflate to the
recommended inflation
pressure.
23. Wipe off any sealant from the
wheel, tyre or vehicle.
24. Dispose of the used tyre
sealant canister at a Holden
Dealer or in accordance with
local and State codes and
practices. Replace with a new
canister.
Advertisement
Chapters
Table of Contents
