Table of Contents
Advertisement
9-26
Driving and Operating
system does not need to be
serviced. The system may light up
due to guardrails, signs, trees,
shrubs, and other non-moving
objects. This is normal system
operation; the vehicle does not need
service.
SBZA may not operate when the
SBZA sensors in the left or right
corners of the rear bumper are
covered with mud, dirt, snow, ice,
or slush, or in heavy rainstorms. For
cleaning instructions, see "Washing
the Vehicle" under Exterior Care on
page 10-62. If the DIC still displays
the SIDE DETECTION SYSTEM
UNAVAILABLE message after
cleaning the rear bumper corners,
see your dealer. This message may
also be displayed when driving near
sites where the SBZA system could
cause interference.
If the SBZA displays do not light up
when vehicles are in the blind zone
and the system is clean, the system
may need service. Take the vehicle
to your dealer.
When SBZA is disabled for any
reason other than the driver turning
it off, the Side Blind Zone Alert On
option will not be available on the
personalisation menu.
Rear Vision
Camera (RVC)
Warning
Never rely solely on the reverse
camera when reversing the
vehicle.
There is a blind spot that can not
be sensed by the rear view
camera.
The reverse camera is not
intended to replace the driver's
judgement or attention toward the
rear of the vehicle when
reversing.
Warning (Continued)
Before entering the vehicle
always check that the area
around the vehicle is clear of
obstacles and people.
Always perform head checks and
use the vehicle's mirrors when
reversing.
If the vehicle sustains any
damage in the area of the reverse
camera (boot lid), the camera
may become misaligned. Contact
a Holden Dealer.
Always keep the camera lens free
from dirt, snow or ice. Only use
mild soap and water with a soft
cloth to clean the lens.
A view of the area behind the
vehicle is displayed on the
infotainment screen, when reverse
(Continued)
gear is selected.
Advertisement
Chapters
Table of Contents
