Table of Contents
Advertisement
This is a temporary puncture repair.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
Inflating tyres without sealant
1. Lift the lever (7) and pull the
air-only delivery hose (4) from
the bottom of the kit.
2. Remove the tyre valve cap by
rotating it anticlockwise.
3. Push the air-only delivery
hose (4) onto the tyre valve and
push the lever (7) down to
secure.
4. Plug the 12 volt power
connection (6) into the vehicles
power socket. See Power
Outlets on page 5-9.
Do not jam the 12-volt power
connection cable in the door,
boot or window.
5. Start the engine and let it idle to
ensure the battery does not
run down.
Warning
Do not run the engine in an
enclosed area or with passengers
in the vehicle. See Fuel on
page 9-34 for exhaust gas
warnings.
6. Switch the on/off switch (1) to
the I position.
Vehicle Care
Warning
Do not over inflate tyres due to
risk of injury or damage to the
tyre. Refer to the tyre placard for
recommended inflation pressure.
7. Check the pressure gauge (2).
If there is no pressure reading
while the compressor is running,
check for leaks at the connection
between the hose and the tyre
valve.
8. Inflate the tyre to the
recommended inflation pressure
using the air pressure gauge (2).
The pressure gauge (2) reads
slightly high while the
compressor is on.
9. Switch the compressor off to get
an accurate reading.
The compressor may be
switched on and off until the
correct pressure is reached.
10-47
Advertisement
Chapters
Table of Contents
