Tyre Changing - HOLDEN WN CAPRICE 2014 Owner's Handbook Manual

4. Push the air-only delivery
hose (4) onto the tyre sealant
canister (3) inlet.
5. Push the lever (7) down.

Tyre Changing

Warning
All passengers must be out of the
vehicle when it is being jacked.
Do not jack a vehicle with a trailer
attached. Remove the trailer first.
Only jack the vehicle on hard,
level surfaces.
Ensure moving parts of the jack
are adequately lubricated
before use.
Use the jack only at the
designated lifting points. Use in
other locations may result in the
vehicle falling off the jack,
or damage to the vehicle.
(Continued)
Warning (Continued)
If using a jack (or hoist) other
than the jack supplied with the
vehicle, see Trolley jack or
vehicle hoist under Tyre
Changing on page 10-49.
Do not start or run the engine
while the vehicle is supported by
the jack.
Use the jack only for lifting the
vehicle when changing wheels.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
Vehicles with alloy wheels may
have a steel spare wheel. Drive
carefully and do not exceed
80 km/h if the tyre size or tread
pattern of the spare tyre is
different to the other tyres on the
vehicle. Although the spare tyre
(Continued)
Vehicle Care
Warning (Continued)
was fully inflated when the vehicle
was new, it can lose air over time.
Check the inflation pressure
regularly.
After installing the spare tyre on
the vehicle, stop as soon as
possible to check the inflation
pressure is correct. Have the flat
tyre repaired or replaced and
installed back on the vehicle as
soon as possible.
For petrol vehicles, see Procedure
petrol vehicles later in this
section.
For LPG vehicles, see Procedure
LPG vehicles later in this section.
Procedure petrol vehicles
1. Park on a hard, level surface, in
a safe location.
2. Apply the park brake.
10-49