Mrp Timer Leaveall - H3C IE4300 Command Reference Manual

Parameters
timer-value
following requirements:
•
Greater than two times the Join timer.
•
Less than the LeaveAll timer.
•
Divisible by 20 centiseconds.
Examples
# Set the Leave timer to 100 centiseconds. (In this example, the Join timer and LeaveAll timer use
their default settings.)
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer leave 100
Related commands
display mvrp running-status
mrp timer join

mrp timer leaveall

mrp timer leaveall
Use
mrp timer leaveall
Use undo mrp timer leaveall
Syntax
mrp timer leaveall timer-value
undo mrp timer leaveall
Default
The LeaveAll timer is 1000 centiseconds.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameter
timer-value
the following requirements:
•
Greater than any Leave timer on each port.
•
Not greater than 32760 centiseconds.
•
Divisible by 20 centiseconds.
Usage guidelines
Each time the LeaveAll timer of a port expires, all attributes of the MSTIs on the port are deregistered
throughout the network. To prevent this type of deregistration from affecting the network, do not set
the LeaveAll timer to less than its default value.
: Specifies the Leave timer value (in centiseconds). The Leave timer must meet the
to set the LeaveAll timer.
: Specifies the LeaveAll timer value (in centiseconds). The LeaveAll timer must meet
to restore the default.
7