Snmp-Agent Trap Enable Ifmonitor - H3C IE4300 Command Reference Manual

Syntax
shutdown
undo shutdown
Default
Ethernet interfaces are in up state.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
Executing the
interrupt communication. Use this command with caution.
Some interface configurations might require an interface restart before taking effect.
The
shutdown
The
shutdown
Examples
# Shut down and then bring up GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] shutdown
[Sysname-GigabitEthernet1/0/1] undo shutdown

snmp-agent trap enable ifmonitor

Use
snmp-agent trap enable ifmonitor
Use
undo snmp-agent trap enable ifmonitor
NOTE:
This command is supported only in Release 6340 and later.
Syntax
snmp-agent trap enable ifmonitor [ crc-error | input-error | output-error ]
*
undo snmp-agent trap enable ifmonitor [ crc-error | input-error |
output-error ] *
Default
Interface alarm functions are enabled.
Views
System view
command on an interface will disconnect the link of the interface and
shutdown
command cannot be executed on an interface in a loopback test.
, , and
port up-mode
commands are mutually exclusive.
loopback
to enable interface alarm functions.
to disable interface alarm functions.
41