Flow-Control - H3C IE4300 Command Reference Manual

IMPORTANT:
Fiber ports do not support this command.
Use
eee enable
Use
undo eee enable
Syntax
eee enable
undo eee enable
Default
EEE is disabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
With EEE enabled, a link-up interface enters low power state if it has not received any packet for a
period of time. The time period depends on the chip specifications and is not configurable. When a
packet arrives later, the interface restores to the normal state.
Examples
# Enable EEE on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] eee enable

flow-control

Use
flow-control
Use
undo flow-control
Syntax
flow-control
undo flow-control
Default
TxRx-mode generic flow control is disabled on an Ethernet interface.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
With TxRx-mode generic flow control configured, an interface can both send and receive flow control
frames:
to enable Energy Efficient Ethernet (EEE) on an interface.
to disable EEE on an interface.
to enable TxRx-mode generic flow control on an Ethernet interface.
to disable TxRx-mode generic flow control on the Ethernet interface.
23