Mrp Timer Periodic - H3C IE4300 Command Reference Manual

To keep the dynamic VLANs learned through MVRP stable, do not set the LeaveAll timer less than its
default value.
The device randomly changes the LeaveAll timer within a certain range when an MRP participant
restarts its LeaveAll timer. This prevents the LeaveAll timer of a particular participant from always
expiring first.
Examples
# Set the LeaveAll timer to 1500 centiseconds. (In this example, the Leave timer on each port uses
the default setting.)
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer leaveall 1500
Related commands
display mvrp running-status
mrp timer leave

mrp timer periodic

Use
mrp timer periodic
Use
undo mrp timer periodic
Syntax
mrp timer periodic timer-value
undo mrp timer periodic
Default
The Periodic timer is 100 centiseconds.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
timer-value
Usage guidelines
Setting the Periodic timer to 0 disables the Periodic timer.
Setting the Periodic timer to 100 enables the Periodic timer. The participant then sends MRP frames
at an interval of 100 centiseconds.
Examples
# Disable the Periodic timer.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer periodic 0
Related commands
display mvrp running-status
to set the Periodic timer.
: Specifies the Periodic timer, which can be 0 or 100 centiseconds.
to restore the default.
8