Duplex; Eee Enable - H3C IE4300 Command Reference Manual

Field
Status
Interval
Threshold
Related commands
link-flap protect enable
port link-flap protect enable

duplex

Use
duplex
Use
undo duplex
Syntax
duplex { auto | full | half }
undo duplex
Default
An Ethernet interface operates in autonegotiation mode.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
: Configures the interface to autonegotiate the duplex mode with the peer.
auto
: Configures the interface to operate in full duplex mode. In this mode, the interface can receive
full
and transmit packets simultaneously.
: Configures the interface to operate in half duplex mode. In this mode, the interface can only
half
receive or transmit packets at a given time. Fiber ports, 1000-Mbps Ethernet interfaces, and
10000-Mbps Ethernet interfaces do not support this keyword.
Examples
# Configure GigabitEthernet 1/0/1 to operate in full duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] duplex full

eee enable

Description
•
Enabled—Link flapping protection is enabled on an interface.
•
Disabled—Link flapping protection is disabled on an interface.
Status of an interface:
•
Down—The interface has been shut down by the link flapping protection
feature.
•
N/A—The interface status is not affected by the link flapping protection feature.
Link flapping detection interval for an interface.
Link flapping detection threshold for an interface.
to set the duplex mode for an Ethernet interface.
to restore the default.
22