Display Transceiver Alarm - H3C IE4300 Command Reference Manual

Table 13 Command output
Field
System state
Redundancy state
Role
State
*
Related commands
display device

display transceiver alarm

Use
display transceiver alarm
Syntax
display transceiver alarm interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]
number. If no interface is specified, this command displays the alarms present on every transceiver
module.
Usage guidelines
Table 14 shows the common transceiver alarm components. If no error occurs, "None" is displayed.
Description
System status:
Stable—The system is operating stably.
System redundancy status:
•
Stable—Member devices are operating stably. You can perform a switchover.
•
No redundance—The system has only one member device. You cannot perform
a switchover.
•
Not ready—The system is not operating stably. You cannot perform a switchover.
Role of the member device in the system:
•
Active—The member device is the master.
•
Standby—The member device is a subordinate member.
Member device status:
•
Stable—The member device is operating stably.
•
Board inserted—The member device has just been installed.
•
Kernel initiating—Member device kernel is being initialized.
•
Service starting—Services are starting on the member device.
•
Service stopping—Services are stopping on the member device.
•
HA Batch backup—An HA batch backup is going on.
•
Interface data batch backup—An interface data batch backup is in progress.
The object is not operating stably.
to display transceiver alarms.
: Specifies an interface by its type and
30