Table of Contents
Advertisement
Select the NewLine check box as needed, and then set separator types of OSD
Step 6
information.
You can manually enter other separators when selecting Custom from Osd Separator.
Step 7
Set OSD options.
Parameter
Insert Before
Insert After
Edit
Delete
Clear
New Line
Step 8
Click Confirm.
4.5.1.4 Cutout Configuration
4.5.1.4.1 Snapshot Cutout
Enable plate cutout function, and the system will cut out the recognized plate picture, and save it to
the storage path.
Step 1
Select Setting > ITC > Cutout.
Step 2
Select On, and select Plate or Whole Vehicle, and then the function of plate cutout or
whole vehicle cutout is enabled.
Step 3
Click Confirm.
Figure 4-39 New line, and OSD separator
Table 4-16 Snap OSD parameters description
Description
Select one OSD option, click Insert Before, and select other OSD options.
The new OSD options will be displayed before original OSD option.
Select one OSD option, click Insert After, and select other OSD options.
The new OSD option will be displayed after the original OSD option.
Click it, and all the OSD information status is displayed as
Line. Click
to modify the prefix, suffix, content, and separator of
corresponding OSD option.
Click it, and all the selected OSD information status is displayed as
to delete corresponding OSD option.
Delete all the OSD information.
After selecting some OSD information, click New Line, and the OSD
information inserted after NewLine will be displayed in a new line on the
picture.
Figure 4-40 Snap cutout
37
User's Manual
except New
, click
Advertisement
Table of Contents
