Table of Contents
Advertisement
5
Configuration on the Webpage
This section only introduces the configuration steps of ANPR function. For more functions, see the user's
manual.
Synchronizing the Time
On the home page, select Setting > System > General > Date & Time.
Set the time zone to Beijing, click Sync PC or manually enter the time to synchronize the
system time, and then click Save.
Configuring the Line
On the home page, select Setting > Event > ANPR Snap > Illegal Capture.
Select lane 1, click Lane Line to draw lane lines in the monitoring image, and then click
Detection Line to draw detection line on the lane lines.
The detection line should be 23 m away from the camera.
Repeat the steps to draw lane lines and detection lines for lane 2 and lane 3.
Click Area Line in Vehicle Detection to draw the area lines on the lower part of the image.
After the configuration is complete, enable the events for the lanes, and then click Save.
12
Construction Guide
Advertisement
Table of Contents
