Table of Contents
Advertisement
10. Click Yes, and then click OK on the pop-up window.
● If you select install signed certificate, follow the steps below.
1. Select Setting Safety > System > Safety > HTTPS.
2. Select Enable HTTPS, and Compatible with TLSv1.1, and earlier versions.
3. Click Browse to upload the signed certificate, and certificate key, and then click
4. To install the root certificate, see operation steps from 1.d to 1.j in Create
Select Enable HTTPS, and click Confirm.
Step 2
The configuration takes effect until the Camera restarts.
Step 3
Use HTTPS to log in to the Camera.
1. Enter https://xx.xx.xx.xx in the browser.
xx.xx.xx.xx is the device IP address or domain name.
2. Enter the username, and password to log in to the Camera.
The browser will prompt certificate error if certificate is not installed.
4.5.6.3.3 Firewall
Set the security rules to protect the safety of your camera system.
Step 1
Select Setting > System > Safety > Firewall.
Step 2
Select Rule Type.
● Network Access: Add the IP address to allowlist or blocklist to allow or restrict it to
access corresponding ports of the device.
● PING Prohibited: IP address of your camera is prohibited from ping. This helps prevent
attempt of accessing your network system without permission.
● Prevent Semijoin: Prevents half-open SYN attacks.
Step 3
Select On to enable the selected rule type.
Step 4
Click Confirm.
Upload.
Certificate.
Figure 4-93 Restart device
Figure 4-94 Firewall
78
User's Manual
Advertisement
Table of Contents
