Table of Contents
Advertisement
Parameter
Trigger Mode Config
IO Config
Step 4
Click Confirm.
4.5.1.2 Intelligence
4.5.1.2.1 Recognition
You can set vehicle recognition parameter, recognition mode, and some other functions.
Step 1
Select Setting > ITC > Intelligence > Intelligent Analysis > Recognition.
Table 4-13 Loop I/O parameters
Description
IO
Only Loop I/O can be selected.
Loop 1
Set the loop trigger mode.
● Not triggered: No capture is triggered.
● Rise Edge: Capture is triggered when the vehicle
enters loop.
● Fall Edge: Capture is triggered when the vehicle
Loop 2
exits loop.
When the scheme is single_in1-snap, then loop 2 can
not be set.
● Set IO snapshot scheme.
● Single_in_1: Lay single loop, and it will take a
snapshot when the vehicle enters a loop.
Scheme
●
Double_in_1: Lay double loops, and it will take a
snapshot when the vehicle enters the first loop.
● Double_in_2: Lay double loops, and it will take a
snapshot when the vehicle enters the second loop.
Select the corresponding relationship between logical
loop and physical loop.
Loop
Mapping
● When the scheme is single_in_1, only need to select
the physical loop corresponds to logical loop 1.
● You need to configure this in mix mode.
32
User's Manual
Advertisement
Table of Contents
