Table of Contents
Advertisement
Parameter
General config
Step 3
Click Confirm.
4.5.1.7 RS-485 LED Display
Connect the LED display with the Camera through RS-485, and then you can configure the status,
display type, display color, action, speed, and more parameters of the LED.
Step 1
Select Setting > ITC > RS-485 LED Display.
Step 2
Configure LED parameters.
Parameter
Entrusting Mode
Working Mode
LED Display Status
Description
Common
Click to restore to commonly selected fields (default).
Config
Up/Down
Click to move the field position up or down.
Tag Head
The tag head of data package. It is aabb by default.
Tag Tail
The tag tail of data package. It is aa55 by default.
Encode
Select encode type from UTF-8 (default) and GB2312.
Type
Select check mode from No Parity, CheckSum and XOR
Check
Mode
Check.
Figure 4-51 RS-485 LED display
Table 4-21 LED parameters description
Description
Select On, and then the LED will be totally controlled by superior platform.
The protocol must be supported by the platform.
● Platform Mode: Select this to allow platform to control LED display
information.
● Standalone Mode: Display as configured, and not controlled by any
platforms.
Select from Car Pass State, and Normal Status. The LED screen will
display as configured during the time period of either status.
44
User's Manual
Advertisement
Table of Contents
