Table of Contents
Advertisement
Step 2
Configure the parameters.
Parameter
Work Mode
Number of Snapshots
Capture Direction
Video Mode Parameters
Loop Mode Parameters
Step 3
Click Confirm.
4.5.1.1.2 IO
You can configure loop IO snapshot parameters.
Step 1
Select Setting > ITC > Snapshot Settings > IO.
Step 2
Select Loop I/O check box.
Step 3
Configure parameters.
Table 4-12 Description of capture parameters
Description
● Loop: Use loop to take snapshots.
● Video: Use video to take snapshots.
● Mixmode: Use loop and video to take snapshots.
It can take 1–2 snapshot(s).
● Approaching: Only captures vehicles that approach.
● Departing: Only captures vehicles that depart.
● Two-way: Captures vehicles that approach or depart.
● Scene: Select Small Vehicle or Large Vehicle as needed.
● Licensed Vehicle Frame Threshold: Configure the frame number
of capturing licensed vehicle. 1 (default) means to capture when
detecting one frame of licensed vehicle passing detection area.
● Unlicensed Vehicle Frame Threshold: Configure the frame
number of capturing unlicensed vehicle. 10 (default) means to
capture when detecting 10 frames of unlicensed vehicle passing
detection area.
● Max Pass Time: Configure the maximum time for vehicle passing.
5 s (default) means that under loop mode, the capture will not
take snapshots when both loops are triggered within 5 s interval.
● Loop Cache Frame: Configure the cache frame number of loop. 3
(default) means to save 3 frames of loop detection result.
Figure 4-31 IO
31
User's Manual
Advertisement
Table of Contents
