Table of Contents
Advertisement
4.5.4.2 Abnormality
Set relay-out mode of different events. When abnormality happens, system triggers alarm.
Step 1
Select Setting > Event > Abnormality.
Step 2
Select events from SD card, network error, illegal access, security exception and blocklist
car as needed.
Step 3
(Optional) Select event type. You only need to select this for SD card and network error.
Step 4
Click On to enable various abnormalities.
Step 5
Configure parameters of each event.
Parameter
Enable
Relay-out
Signal Duration
Capacity Limit
Login Error
Send Email
Click Confirm.
Step 6
4.5.5 Storage
This section provides guidance on setting associated information of storage, and record control.
Figure 4-72 No storage card
Table 4-37 Abnormality parameters description
Description
Check to enable corresponding abnormality event.
Check to enable the corresponding alarm output of abnormality event, and
select the corresponding port.
The alarm linkage keeps running for the defined time after alarm ends.
The time range is 10 s–300 s.
Configure the storage available that triggers abnormality alarm.
Only need to configure when setting Event Type to Scarcity of Storage
Space in SD Card.
Configure the number of login error allowed. The range is 3–10 times.
Only need to configure when setting Illegal Access.
The system sends an email to the defined email address when an alarm is
triggered. To set the email address, go to Setting > Network >
SMTP(Email).
Only need to configure when setting Illegal Access and Blocklist Car.
64
User's Manual
Advertisement
Table of Contents
