Register Products-Mandatory To Validate Slas; Mounting A Qfx5200 In A Rack Or Cabinet; Before You Begin Rack Installation - Juniper QFX5200 Hardware Manual

Register Products—Mandatory to Validate SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
CAUTION: Register product serial numbers on the Juniper Networks website and
update the installation base data if there is any addition or change to the installation
base or if the installation base is moved. Juniper Networks will not be held accountable
for not meeting the hardware replacement service-level agreement for products that do
not have registered serial numbers or accurate installation base data.
Register your product(s) at
Update your installation base at
updateinstallbase.jsp.

Mounting a QFX5200 in a Rack or Cabinet

IN THIS SECTION

Before You Begin Rack Installation | 99

Four Post Installation Procedure for QFX5200-32C or QFX5200-32C-L | 101
Four Post Installation Procedure for QFX5200-48Y | 102
You can mount all QFX5200 switches on a four post 19-in. rack or cabinet using the mounting kit
provided with the switch.
For four post rack or cabinet installations, the mounting kit contains two front mounting rails with two
matching rear mounting blades. This configuration allows either end of the switch to be mounted flush
with the rack and still be adjustable for racks with different depths.
(The remainder of this topic uses "rack" to mean "rack or cabinet.") The front and rear rack rails must be
spaced between 23.5 in. (59.7 cm) and 30.6 in. (77.7 cm) front to back.
This topic describes:
Before You Begin Rack Installation
Before you begin mounting a QFX5200 switch in the rack or cabinet:
https:/ /tools.juniper.net/svcreg/SRegSerialNum.jsp.
https:/ /www.juniper.net/customers/csc/management/
99