Rear Brake Disc Installation; Front Brake Disc Removal - APRILIA TUAREG 660 Service Station Manual

Braking system
Installing
After checking the integrity and the state of wear
of the brake disc, if it is not replaced with a new
disc, proceed as described to carry out the fitting:
•
Position the brake disc on the rim, mak-
ing sure it is in the correct direction of
installation.
WARNING
THE FLAT SURFACE MUST BE IN CONTACT WITH THE
RIM WHILE THE MILLED SURFACE MUST BE FACING
OUTWARDS.
•
Insert the five screws and tighten them
to torque in the order shown (A-B-C-D-
E).
Front brake disc
Removal
To remove the front brake disc, after removing the
wheel, proceed as described:
THE FOLLOWING OPERATIONS REFER TO
ONE DISC BUT APPLY TO BOTH
•
Remove the five fixing screws (1) of the
tone wheel (if applicable) and of the
brake disc on the rim.
BRAK SYS - 246
TUAREG 660