Control Unit; Location Of The Main Fuse; Engine Tone Wheel Programming Procedure - APRILIA TUAREG 660 Service Station Manual

Electrical system
•
Unhook the front part of the side panel
(4) to move it out of the away and ac-
cess the main fuse.
•
Disconnect the connector (5) to access
the main fuse (O).
•
Remove the fuse and check whether
the filament (2) is broken.
•
Before replacing the fuse, find and
solve, if possible, the reason that
caused the problem.
•
If the fuse is damaged, replace it with
one of the same current rating.
NOTE
IF THE SPARE FUSE IS USED, REPLACE WITH ONE OF
THE SAME TYPE IN THE CORRESPONDING FITTING.
CAUTION
REMOVING THE 30A FUSE WILL RESET THE: DIGITAL
CLOCK AND TRIP INFORMATION.
Specification
O) 30A fuse
P) spare fuse
The main fuse is located behind the left hand side fairing of the motorcycle, under the rider saddle.

Control unit

ENGINE TONE WHEEL PROGRAMMING PRO-
CEDURE
•
Using the PADS diagnostic tool, per-
form the "Reset wheel tooth values";
•
Bring the engine to a temperature
above 80°;
Then proceed as described:
•
In neutral position, with the side stand
extended/open and with the vehicle
absolutely immobile, quickly bring the
ELE SYS - 120

LOCATION OF THE MAIN FUSE

TUAREG 660
Desc./Quantity
Battery charging, all vehicle utilities