Steering Bottom Yoke Removal - APRILIA TUAREG 660 Service Station Manual

Suspensions
•
Place the handlebar (7) on the lower U-
bolts.
•
Position the upper U-bolt (8) with the
four fixing screws (9).
•
Adjust the handlebar with the "0" refer-
ence mark aligned with the lower U-
bolt and tighten the screws (9) to
torque.
•
Working from both sides, secure the
electrical component wiring harnesses
of the handlebars to the steering triple
clamp with two clamps.
Steering bottom yoke
Removing
To remove the lower triple clamp it is necessary to
first remove the front wheel complete with mud-
guard, the upper triple clamp and the stanchions.
Then proceed as described:
•
Remove the steering safety plate (1).
•
Remove the upper steering ring nut (2)
using the special tool.
Specific tooling
AP8140190 Steering tightening tool
SUSP - 146
TUAREG 660