Installation Of External Wheel Components (Rear) - APRILIA TUAREG 660 Service Station Manual

TUAREG 660
•
Fit the internal spacer (14) from the op-
posite side.
•
Position the bearing (15) in its seat and
use the appropriate punch to insert as
far as it will go.
Specific tooling
020376Y Adaptor handle
020359Y 42 x 47 mm Adaptor
INSTALLATION OF EXTERNAL WHEEL COM-
PONENTS
To proceed with the installation of the internal
wheel components, proceed as described:
•
Position the brake disc (16) on the hub
making sure of the correct orientation,
determined by the markings which
must face outwards.
•
Carefully and progressively, screw the
five screws securing the tone ring/
clutch plate following the order A-B-C-
D-E.
CAUTION
PAY CAREFUL ATTENTION TO TIGHTENING THE FIVE
SCREWS. ALWAYS PROCEED GRADUALLY AND PRO-
GRESSIVELY ON EACH SCREW.
•
Torque tighten the five screws in the order A-B-C-D-E.
Chassis
CHAS - 185