Electrical system
TABLE M1 - ROUTING THE CABLES IN THE
INSTRUMENT PANEL SUPPORT AREA
•
After passing all the cables and fixing
the right instrument panel support, pull
and hold the following cables: throttle
control, right switch cluster, left switch
cluster, clutch switch, ignition wiring
and antenna wiring. Once they have all
been pulled, fasten the clamp highligh-
ted by the arrow in the photo. Once
fastened, let go of the cables and po-
sition them for the next step.
TABLE M2 - ROUTING THE CABLES IN THE
INSTRUMENT PANEL SUPPORT AREA
•
Keep the wiring harness of the left
switch cluster (1) as far to the left as
possible
•
Position the rest of the cables as in the
photo and fasten the other two clamps
indicated.
ELE SYS - 70
TUAREG 660