TUAREG 660
•
Tighten the rear wheel locking nut to
the prescribed torque.
•
Rotate the wheel a few times to check that it does not stick.
Swinging arm
Removing
Using straps, block the front part, position a scissor
lift centrally to keep the rear part raised when re-
moving the swingarm.
To proceed with the removal of the swingarm, it is
necessary to first remove the rear wheel, rear
mudguard and chain cover.
•
Then proceed with the removal of the
rear brake calliper complete with sup-
port by disconnecting the brake line
and the rear ABS sensor wiring har-
ness from the three cable guides on the
swingarm.
•
Position a rear stand to support the
swingarm and unscrew the nut (1) and
remove the screw (2) fixing the dual
linkage to the swingarm.
•
Then if necessary remove the bush (3).
Chassis
CHAS - 189