Abs Control Unit Connector Insertion - APRILIA TUAREG 660 Service Station Manual

TUAREG 660
In case of replacement of the ABS control unit, ensure that the new one has caps on all four hydraulic
connections and then proceed as follows:
•
After connecting the new ABS control unit hydraulically and electrically, it must be activated/
recognised.
•
Do a "KEY ON".
•
Check that the ABS warning light flashes rapidly.
•
Do a "KEY OFF" followed by a "KEY ON".
•
If activation has been successful, the warning light should come on and flash slowly.
•
In the event of a fault, with the diagnostic tool disconnected, the warning light should be
permanently lit.
•
Connect the diagnostic tool and check for errors.
ABS CONTROL UNIT CONNECTOR INSERTION PROCEDURE
•
The initial position of the connector coupling lever must be as indicated in the figures.
•
Place the connector on the opposite
side of the control unit and lower the
driving lever until the "click" that signals
the end of the stroke is heard.
Braking system
BRAK SYS - 231