APRILIA TUAREG 660 Service Station Manual page 220

Chassis
•
Remove the special screw (6) used to
fasten the centre stand and then sep-
arate it from the plate.
•
Remove the washer (7).
NOTES FOR THE REFIT PHASE:
•
Check the correct positioning of the side stand sensor, in particular that the sensor pin is
engaged in the hole on the stand.
CAUTION
INCORRECT POSITIONING OF THE SIDE STAND SENSOR
CAN GENERATE THE "STAND OPEN" SIGNAL, THERE-
FORE INHIBIT THE START.
CHAS - 220
TUAREG 660