Vertical Adjustment Of The Light Beam; High Beam Headlight - APRILIA TUAREG 660 Service Station Manual

Maintenance
To carry out vertical adjustment of the light
beam:
(LOW BEAM HEADLIGHTS)
•
Operating from the rear side of the fair-
ing, under the internal bodywork, act
on the adjuster ("1" left side / "2" right
side). SCREWING (clockwise) the light
beam is lowers; UNDO the screw (an-
ticlockwise) to raise the light beam.
•
These two adjuster screws may be
used to adjust the vertical alignment of
the low beam headlight beam.
NOTE
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM
IS CORRECT.

(HIGH BEAM HEADLIGHT)

From under the light using a Phillips-head screw-
driver, act on the adjuster (3) at the point indicated:
•
Turn the screwdriver clockwise to raise
the beam;
•
Turn the screwdriver anticlockwise to
lower the beam.
This adjuster screw may be used to adjust the ver-
tical alignment of the high beam headlight beam.
NOTE
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM
IS CORRECT.
MAIN - 56
TUAREG 660